Turning off or on running water in shower. Last or first drops splash from faucet. Water consumption, bill, saving, shortage and ecology concept. Dripping shower.

How to clean the electric shower without disassembling

Do you often clean the shower in your home? It sounds like a lot of work, well your problems are over. The importance of learning how to clean a shower is because often the holes through which the water comes out become clogged by small dirt that comes with the water. Then the bath starts to get less pleasant because the shower is no longer so strong.

Also, for hygiene reasons, it is important to clean the slime that forms around the holes because of the moisture that is in the bathroom. Doing the cleaning twice a year will have no problems and your shower tends to last longer.

You can clean it using vinegar and water or, if you prefer, you can use bleach. Both methods work very well and are done the same way, so choose the product you have at home to be more practical.

With bleach

This is a tip that mainly helps to leave your shower disinfected and without whitish stains.

  • The first step is to turn off the breaker if your shower has no outlet to avoid electric shock.
  • Take a bag and put some bleach inside.
  • Tie this bag to the mouth of the shower, covering everything where the water comes out. Be careful to tie the bag away from the electrical part so that water does not come into contact with the wires.
  • Turn on the shower and let some water fall into the bag. The intention is for the shower mouth to be in the water mixed with the product.
  • Let the bag with water activities in the shower for half an hour and then you can remove it. Your shower will be clean.

Clear clogged shower with vinegar

This tip is similar to the previous one, but this time the intention is also to remove the limestone, which are very small stones formed by minerals that clog the holes and prevent the outflow of water.

  • Again, the first thing to do is to cut off the power to the shower, either by unplugging or turning off the circuit breaker.
  • Heat some water and when it is very hot (do not need to boil), mix a little vinegar.
  • Then put this solution in a bag and tie it around the shower, just where the water comes out, being careful not to touch the wires.
  • Let it act for half an hour. If the shower is very clogged and dirty, let it act for at least 1 hour or more.
  • Then drop the bag, scrub the shower with a brush and the service is ready. Turn on the shower to check the result.
What if it doesn’t solve?

It may be that your shower has been for years without receiving such cleaning. Even so, these two tips, with vinegar or bleach, are very effective.

So, what you can do is leave the bag with vinegar or bleach in the shower all night to act longer, or repeat the process after the first attempt. It will work.

If your shower is disassembled in the holes, you can loosen the shower after the soak and rub a baking soda brush mixed in a little water. Scrub well, as baking is abrasive and will help loosen limescale. Then rinse and put back in place. Only restart the plug or circuit breaker after the entire process has been completed.