Everyone loses hair when washing in the bath, but what can not happen is to let the hair accumulate and eventually cause clogging in the drain pipe.

5 tips to unclog hair out from drain pipe

If your shower drain brings water back, the problem may be the accumulation of hair stuck in the pipe. See what to do.

Everyone loses hair when washing in the bath, but what can not happen is to let the hair accumulate and eventually cause clogging in the drain pipe. See how to solve this problem.

When hair gets stuck near the drain the removal process is easier, but sometimes it gets stuck on the way out to the sewer. you can’t reach it, and may even end up affecting the efficiency of other drains in the house. So what are the most effective methods to get the plumbing free again?

1. Make sure you can see the tuft of hair stuck in the drain

If you can see the wisps of hair trapped inside the drain, that’s good news. That means you just have to remove the drain seal. put on a glove, and pull the hair out completely (and even other solid objects) as much as you can. Then turn on the shower to test if the water will flow normally, come clog. If so, the problem solved.

2. Wait for the water to drain and check deeper

Even without being able to see the wisps of hair, they may still be closer to the drain outlet and can be removed with a wire.
After all, the water has drained from the drain and the pipe is drier, remove the drain cap and use a flashlight to confirm that you can see hair stuck. Use a piece of wire making a hook at the end to help pull the trapped hair. If you can, open the shower to check that the issue has been resolved.

3. Use a plunger or water pressure

If you notice that the water in the drain does not come down at all, even after a while without opening the shower, there may be another problem, not just the clogging of hair.
Use a plunger, water-filled bucket or hose to apply pressure. Beware of the feet as it can get a lot of dirt back. If even with pressure or plunger the problem persists, go to the next tip.

4. Use homemade product

Before moving on to stronger products, try using a sodium bicarbonate solution. After the water has dried from the plumbing, place ¾ cup of baking soda into the drain. Then another ½ cup of distilled vinegar.

Cover the drain with a rubber stopper to get the products into action and let it work for half an hour. Then boil a kettle of water (about 4 cups), remove the cork from the drain and pour the water all at once. It should help the material soften and go down the pipe.

5. Use a chemical

Be very careful when handling strong products to unclog drains. Do not get too close to the face and only catch with gloves. Use caustic soda following package directions. In the end, it may be necessary to use the plunger again.